Welcome, Guest. Please Login or Register
UGENE Bulletin Board
  Welcome to our forum.
Page Index Toggle Pages: 1
in silico pcr (Read 523 times)
Jul 9th, 2018 at 11:43pm

hatta0   Offline
YaBB Newbies

Posts: 6
I'm trying to use the in silico pcr tool. I have primers that match my sequence, with restriction site added to the 5p end.

If I do in silico pcr with only the 3' part of the primer that matches the target sequence, I get a product.

If I add the restriction site to my primer, and set 'mismatches' equal to the number of added bases, I get no product.

Seems like this should work. Am I doing something wrong?

Clipboard01.png (20 KB | 63 )
Clipboard02.png (19 KB | 59 )
IP Logged
Reply #1 - Jul 10th, 2018 at 3:16pm

Olga Golosova   Offline
YaBB Administrator

Posts: 292
Hello! There is a known issue about PCR In Silico (see UGENE-6136). It seems that you have the same problem. If you would like to be sure that it is so, please share some test data with us and describe the steps you do in more details.

Note that the mentioned issue will be fixed as soon as possible, the fix will be included into UGENE 1.31. version.
IP Logged
Page Index Toggle Pages: 1