Welcome, Guest. Please Login or Register
UGENE Bulletin Board
  Welcome to our forum.
  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
SPAdes taking hours (Read 56 times)
Jun 12th, 2020 at 8:06am

Bte   Offline
YaBB Newbies

Posts: 1
*
 
Hello, this is my first time posting here so please let me know if there is etiquette that i am not aware of. I am trying to assemble 4 sets of paired end sequences in ugene using the Linux version through Ubuntu on my windows laptop. I am using a workflow that reads, trims, and then assembles each pair. Everything is fine until the final step. The workflow has been running for over 5 hours and it has not budged from 92% complete. Is this normal? Should i start over? Any advice is much appreciated
 
IP Logged
 
Reply #1 - Jun 13th, 2020 at 11:03pm

Dmitrii Sukhomlinov   Offline
YaBB Administrator
Russia

Gender: male
Posts: 6
*****
 
Hello. You're OK about the etiquette, don't worry!
As I've understood, you're trying to run the "De novo assembly Illumina PE reads" workflow. The last "Assembly reads with SPAdes" step could require a lot of time, but 5 hours is a bit too much. First of all, left the execution for all night - it's possible, that data you need to process is really very time-consuming. It also depends on the processing power of your computer, so is your machine isn't very quick it definitely could be a bit long. If it won't finish at all, could you, please, share your data with me and I will try to figure it out?
 
IP Logged
 
Page Index Toggle Pages: 1